BTS6000 EV Battery Pack Testing System 500V200A Cycle Life Discharger Equipment
CE-6000 battery test system Introduction:
1. Power battery simulation , C-rate test.
2. Life cycle test .
3. Power test , capacity test , energy density test.
4. Power battery virtual distribution: charge/discharge curve fitting , battery consistency test and evaluation.
5. High rate charge or discharge test.
6. Power battery , serial energy - storage battery module test : single cell voltage , single cell temperature monitoring ( high - voltage equipment ).
Features ( some features required a customization ) :
High-performance charge or discharge test platform developed for high - power battery modules ( or packs ).
1. Power frequency isolation design , combined with low temperature drift , high - performance multi - channel 24 - bit analog - to - digital conversion chip ( ADC ) to achieve higher stabilize accuracy .
2. High - level power density system with multi-channel integration and capable for energy regeneration .
3. HMI operation , smart calibration .
4. Multiple adaption for BMS , supports the same / different charge and discharge ports , relay / MOSBMS solution , independent CAN and RS485 communication expansion, and DBC configuration .
5. Remote control available from host computer through Ethernet , channels parallel, pulse and driving simulation available .
6. Man - computer integration interface design , simplified system for easy-understand operating, customized setting available , automatic reminder for termly calibration .
System Specification
The CE-6000 test system is designed to test high - capacity battery modules and packs . This battery test system is distinct from high - level accuracy , stability , dynamical rapid response speed , and multi - channel flexible features .
The CE-6000 system is available for the Direct Current Internal Resistance ( DCIR ) , Cycle Life, and Driving Stimulation tests .
The CE-6000 system is capable of energy regenerative system that maximizes the cost efficiency by allowing the electrical energy produced during discharge to be returned to the electrical grid . This system supports multiple test channels .
| Charge | Charge modes | Constant current , Constant voltage , Constant current and voltage , Constant power |
| Cut - off condition | Main channel - Voltage , Current , delta Time , Capacity , - delta V |
| Discharge | Discharge modes | Constant current , Constant voltage , Constant power , Constant resistance |
| Cut - off condition | Main channel - Voltage , Current , delta Time , Capacity |
| Pulse | Charge | Constant current , Constant power |
| Discharge | Constant current , Constant power |
| Min pulse width | 100ms |
| Pulse counts | Each pulse step supports 32 different pulses |
| Chg and Dschg switch | Supported |
| Cut-off condition | Voltage, Time |
| Cycle | Max cycles | 65535 |
| Max steps | 254 |
| Cycle nest | Nested loop Function,Max Support 3 Layers |
Product Tags:
|
|
IP20 EV Battery Testing Equipment , 500V 200A Car Battery Discharge Tester Images
|
